SoundOff Signal TrafficMaster Split Arrow Bar - Manual

SPLIT ARROW LED TRAFFIC MASTER Page 6 Page 5 SPLIT ARROW LED TRAFFIC MASTER
Figure 2. Mounting Configurations
(View shown from rear of LED Bar)
3. Mount the Split Arrow LED Traffic Master bracket on the front or rear of
the light bar frame as desired. Use either existing holes in the light bar
frame, if available, or drill holes as needed.
NOTE
Remember to properly seal all holes made in any light bar to
prevent water damage.
4. Turn the light bar right side up and attach the Split Arrow LED Traffic
Master to its mounting bracket as shown in Figure 4. Use ONLY 5 x
10mm bolts.
5. Put the light bar on the vehicle roof making sure not to scratch the ve-
hicle. Check for clearance below the light bar as you proceed.
6. Reposition the light bar and secure it to the vehicle.
7. Tighten the bolts that hold the Split Arrow LED Traffic Master mounting
bracket to the light bar, checking that the brackets are aligned with each
other. Some adjustment of these brackets may be required to insure
that the directional signal is level. Adjust as necessary.
8. Position the Split Arrow LED Traffic Master in the center of the vehicle
and tighten the bolts that hold it to the mounting bracket.
Figure 3. Rear Deck Mounting
Figure 4. Light Bar Mounting
NOTE
Use 5 x 10mm Bolt ONLY when
attaching “L” Bracket to the
back of the LED Bar.
NOTE
Use 5 x 10mm Bolt ONLY when
attaching “L” Bracket to the
back of the LED Bar.
TO
FRONT OF VEHICLE
(OPTIONAL WIRING)
LIGHTBAR 2
LIGHTBAR 1
TO
REAR OF VEHICLE
(STANDARD WIRING)
LIGHTBAR 1
LIGHTBAR 2