SoundOff Signal UltraLITE Exterior Warning Bar 8 Module - Manual

WARNING : Warning devices are strictly
regulated and governed by Federal, State and
Municipal ordinances. These devices shall be
used ONLY on approved vehicles. It is the sole
responsibility of the user of these devices to
ensure compliance.
EL3D08A(xxx) 3.09
! WARNING
This product contains high intensity LED devices.
To prevent eye damage, DO NOT stare into light
beam at close range.
MOUNTING INSTRUCTIONS
Before starting the installation make certain
you have the correct bracket for your
application. A universal bracket is supplied.
The product is also designed for surface
mounting. Drill holes where required in the
mounting surface. The bolts provided can
slide back and forth in the bar’s rear
channel to align with the mounting holes.
Install the UltraLITE by following the
assembly instructions provided with the
brackets and check for security.
Important: DO NOT over tighten mounting
screws or nuts. This could cause
permanent damage to the light or bracket.
Use appropriate hardware for mounting.
Universal bracket shown is supplied but
mounting screws are customer supplied.
PATTERN SELECTION
Because of the variety of configuring
options see separate sheets for detailed
instructions
BLACK
RED
WHITE 8 MODULE UltraLITE
BROWN
GREEN
BLUE
+Vdc
7.5A FUSE
8 MODULE EXTERIOR BAR
ASSEMBLY INSTRUCTIONS
12v: EL3DØ8AØØ(x)
10-30v: EL3DØ8AØØ(x)-24
10-30v w/ 50’ CABLE: EL3DØ8A(x)L(x)-24
UNIVERSAL BRACKET
SUPPLIED BAR
MOUNTING HARDWARE
Input Voltage (+Vdc): EL3DØ8AØØ(x) 10-16Vdc
EL3DØ8AØØ(x)-24 10-30Vdc
Current: 4 Amps Maximum
WIRE HOOK-UP TABLE
Wire Color Connect to:
Blue Input 1 / Left
Green Input 2 / Right
Brown Input 3 / Warning
Red +Vdc
Black Ground (-)
White Pattern Select