E-flite PT-19 450 ARF User Manual
Page 8
8
E-flite PT-19 ARF Assembly Manual
9. Use a piece of medium grit sandpaper to
roughen the ends of the servo mounting blocks.
This will help the epoxy to adhere to the blocks
and provide a more secure bond between the
blocks and servo cover.
10. Mix a small amount of 6-minute epoxy. Use the
epoxy to glue the blocks to the servo cover. Use the
lines drawn on the servo cover to properly position
the block.
11. Repeat the steps 2 through 10 to glue the
blocks on the remaining servo cover at this time.
Allow the epoxy to fully cure before proceeding.
12. Once the epoxy has fully cured, position the
servo between the servo mounting blocks.
13. Use a pencil to mark the positions for the servo
mounting screws onto the mounting blocks.
14. Use a pin drill and 1/16-inch (1.5mm) drill
bit to drill a hole in each mounting block at the
position marked in the previous step.
15. Place 2–3 drops of thin CA into each of the
holes to harden the surrounding wood. This will
provide a harder surface for the screws to bite into
and make them more secure when installed.