E-flite PT-19 450 ARF - Manual (Page 28)

28 E-flite PT-19 ARF Assembly Manual
 2. Cut four strips of card stock that are 3/8-inch
(9mm) wide and 4 inches (100mm) long.
 3. Use low-tack tape to attach a piece of card stock
that will align with the front edge of the fuselage
and with the cowl mounting plates that are inside
the fuselage.
 4. Place the cockpit hatch back into position on the
top of the fuselage.
 5. Slide the cowling onto the front of the fuselage.
Make sure the pieces of card stock are positioned
on the outside of the cowl.
 6. Slide the propeller adapter onto the motor shaft.
Use the adapter to help align the opening in the
front of the cowl centered with the adapter and
motor shaft.