E-flite PT-19 450 ARF - Manual (Page 19)

19 E-flite PT-19 ARF Assembly Manual
 4. Insert the rudder servo into the opening in the
servo tray inside the fuselage with the output shaft
toward the tail of the fuselage. Use a pencil to
mark the positions for the servo mounting screws
onto the servo tray.
 5. Remove the rudder servo. Use a pin drill
and 1/16-inch (1.5mm) drill bit to drill a hole
in the servo tray at the position marked in the
previous step.
 6. Place 2–3 drops of thin CA into each of the
holes to harden the surrounding wood. This will
provide a harder surface for the screws to bite into
and make them more secure when installed.
 7. Mount the servo to the servo tray using the two
screws provided with the servo. Use a #1 Phillips
screwdriver to tighten the screws. Slide the pushrod
into the pushrod connector at this time.
 8. Use a ruler placed against the rudder and fin to
align the rudder with the fin.
 9. Check to make sure the rudder servo is
centered using the radio system. Use a #1
Phillips screwdriver and 2mm x 4mm machine
screw to secure the rudder pushrod in the brass
pushrod connector.