Rockwell Automation FactoryTalk Historian SE 3.0 H2H Interface User Guide - Manual (Page 78)

Startup Command File
72
Tag Attribute Override
.BAT .INI Description
/c1
Optional
-- Location1 tag attribute override.
Load all tags configured for the specified point source
regardless of Location1and interface ID values.
/c2=#
Optional
-- Location2 tag attribute override.
Ignore Location2 for each tag and use the
specified value. Valid values are 0-7.
/c3=#
Optional
-- Location3 tag attribute override.
Ignore Location3 for each tag and use the
specified value. Valid values are 0-15.
/c4=#
Optional
-- Location4 tag attribute override.
Ignore Location4 for each tag and use the
specified value. Valid values are 1 (exception data
collection) or 2 (archive data collection).
/c5=#
Optional
-- Location5 tag attribute override.
Ignore Location5 for each tag and use the
specified value. Valid values are 0-3.
/ptid
Optional
--
Source tag point ID is specified in UserInt1
attribute. Ignore InstrumentTag , Exdesc and
Tag name attributes.
Note: this switch is not compatible with source
Historian Server failover since point IDs will not
necessarily match between source Historian Servers.
If the source Historian Servers are part of a Historian
Collective use
/tn instead.
/tn
Optional
-- Source tag name is same as interface tag name.
Ignore
InstrumentTag , Exdesc and
UserInt1 attributes.
/tnex
Optional
-- Source tag name is located in the Exdesc or Tag
name attribute and the InstrumentTag and
UserInt1 attributes are ignored for identifying
source tag.
Server-Level Failover
.BAT .INI Description
/fst=tag
Optional
-- Name of failover status tag.
/fst=
where is a digital tag on the receiving
Historian Server.
/nt=#
Optional
Default:
/nt=1
-- Number of reconnection attempts to source Historian
Server before initiating a failover. Valid values are 0
and greater.
Prevents failover flip-flop when experiencing
intermittent network updates.