Step 5. reinstall the keypad bracket in the drive – Rockwell Automation GV3000/SE AC Drive ControlNet Network Communication Board, M/N 2CN3000 User Manual
Page 27

Installation
2-15
Step 5.
Reinstall the Keypad Bracket in the Drive
Step 5.1 Place the keypad support bracket back into position. Use a magnetic
screwdriver to fasten it to the heatsink with the screws removed earlier.
Step 5.2 Realign the 26-conductor ribbon cable connector with the connector inside
the slot in the keypad support bracket. Carefully press the ribbon cable
connector in until the retaining clips lock into place.
Step 5.3 Route the Network Drop Cable through the left-most opening at the bottom
Step 5.4 Connect the brown wire to terminal 1 of the 2-connector terminal strip.
Connect the white wire to terminal 2.
Step 5.5 Reconnect any wiring that was removed from the Regulator board.
Step 5.6 NEMA 4X/12 drives only: Before installing the cover, check that the gaskets
on the cover are flat and within the gasket channels.
Step 5.7 Reinstall the cover. Align all cover screws into the heat sink before