Rockwell Automation 6155F-NPWEDC Compact Non-display Computer - Manual (Page 46)

46 Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014
Chapter 5 System Troubleshooting
6. Place the jumper block over pins 2 and 3 for 10 seconds.
7. Return the jumper block to its default position.
8. Reinstall the bottom plate as detailed in Reinstall the Bottom Plate on
page 32 .
9. Follow the steps for Post-configuration on page 31 .
10. During POST, press F2 to access the BIOS set-up utility and reconfigure
settings.
Ship or Transport the
Computer If you need to ship the computer via common carrier or otherwise transport it to
another location for servicing or any other reason, you must first uninstall the
computer and place it in its original packing material.
IMPORTANT The jumper block must be returned to its default position over pins 1
and 2. The computer does not start if you leave the jumper block over
pins 2 and 3.
IMPORTANT When you clear the CMOS, all BIOS settings return to their defaults.
BIOS settings other than default must be reconfigured after clearing
the CMOS.
ATTENTION: Do not ship or transport the computer when it is installed in a
machine, panel, or rack. Doing so can damage the computer. You must uninstall
the computer and place it in its original packing material before shipping. Rockwell
Automation is not responsible for damage incurred to a computer that is shipped or
transported while installed in a machine, panel, or rack.