Start the computer – Rockwell Automation 6155F-NPWEDC Compact Non-display Computer User Manual
Page 26
26
Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014
Chapter 3
Operation
Start the Computer
Follow these steps to start the computer.
1. Make sure any connected components with separate power supplies (such
as an external display) are turned on first.
2. Make sure all necessary peripheral devices are connected to the corresponding
I/O ports on the computer.
3. AC powered models: See
for how to
install the AC power cord into the AC power input on the computer.
DC powered models: See
for how to
install DC power to the DC power input on the computer.
4. AC powered models: Plug the AC power cord into a power source or wall
outlet.
DC powered models: Apply 9…36V DC power to the computer.
5. Press the computer’s power switch.
for the power switch location.
The computer performs certain actions every time it is started or reset. See
Restart the Computer on page 27
for what is done.
If your computer does not start or you notice other anomalies, refer to
IMPORTANT
The following steps apply to when you must manually start the computer. See
for when power is applied to the computer for the
first time.
SHOCK HAZARD: Connect the AC power cord to a power source with an
earth ground to prevent electrical shock. Failure to do so can result in
electrical shock.