Rockwell Automation 6155F-NPWEDC Compact Non-display Computer - Manual (Page 33)

Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014 33
Component Replacement Chapter 4
CompactFlash Card The computers have one external and one internal CompactFlash (CF) Type II
card slots for loading CF cards.
Load a Card in the External CF Card Slot
Follow these steps to load a card in the external CF card slot.
1. Remove the screw that secures the external CF card slot cover (A).
2. Remove the CF card slot cover (B).
3. Insert the CF card into the slot (C) until it is firmly seated.
4. Reattach the CF slot cover (D).
5. Secure the CF slot cover with the one screw (E).
Load a Card in the Internal CF Card Slot
Follow these steps to load a card in the internal CF card slot.
1. Follow the steps for Pre-configuration on page 30 .
2. Remove the bottom plate as detailed in Remove the Bottom Plate on
page 31 .
3. Locate the CF card slot on the motherboard.
IMPORTANT The external CF card slot is hot-swappable. You can insert or remove a card
from this slot while the computer is on.
ATTENTION: When properly seated, more than 80% of the CF card easily
inserts into the slot before you encounter resistance. If you encounter
resistance before then, remove the card, rotate it 180°, and reinsert.
Do not force the card into the slot. Forcing the card into the slot can
damage the connector pins.
IMPORTANT The internal CF card slot is not hot-swappable. You must first shut down the
computer before you can insert or remove a card from this slot.
B D
C
A E