Rockwell Automation 6155F-NPWEDC Compact Non-display Computer - Manual (Page 38)

38 Rockwell Automation Publication 6155R-UM002E-EN-P - February 2014
Chapter 4 Component Replacement
3. Push out the latches on both sides of the SO-DIMM slot (A).
4. Tilt and gently pull the memory module upward to remove it from its slot (B).
5. Place the memory module on a static-dissipating work surface or inside an
antistatic bag.
6. Hold the new memory module by its edge and remove it from its
protective packaging.
7. Orient the module so that the notch on its bottom edge aligns with the
keyed surface of the SO-DIMM slot (C).
8. Tilt and gently press the module
downward to seat it fully into the
slot (D).
The holding clips automatically
lock into place once the module
has been seated.
9. Reinstall the bottom plate as
detailed in Reinstall the Bottom
Plate on page 32 .
10. Follow the steps for Post-configuration on page 31 .
TIP The keyed surface is off center to assist the correct alignment.
A
A
B
D
C
Keyed Surface