Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 76)

Chapter 7
Messages
7 – 13
2. press [
↵
] in response to the query Messages?
3. press [Y] to the query Options?
The DL40 Onboard Editor will display each modifiable Option and give you
a chance to accept the current value or enter a new one. Use the spacebar to
move through the available settings, and press
[
↵
] to accept your choice.
Each time you press [
↵
] , you will move to the next Option. When you have
worked through all the modifiable Options, you will be given a chance to
save your settings and return to Run Mode, or cycle through the list again.
Press
[Y][
↵
] to exit and save or [N][
↵
] to return to the list of Options.
Run Mode
Select the Run Mode for the DL40. See elsewhere in this manual for
complete explanations of all Run Modes.
For Remote I/O versions choose from:
•
Message/ Variable
•
Message/ Variable/Slave
•
Message List
•
Bit Trigger List
For Parallel Port versions choose from:
•
Message/Variable/ Slave
•
Message List
Newest Message on Line 1
In this mode, you will display the newest message to be triggered on line 1
and shift previously triggered messages down. The message on the bottom
line will be shifted off the display. This supersedes the message attribute
Message on Line # Only (messages are still displayed in 20 character pieces).
Compatible with all Run Modes.
Type [Y][
↵
] to activate or [N][
↵
] to deactivate.
Autorun Message Number
An AutoRun Message is a message that will be displayed when your DL40 is
powered up. It can be any message including a message in the Message List.
The AutoRun Message does not support inserted variable data.
Specify a Message Number (a value of 0 deactivates AutoRun Message).