Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 58)

Chapter 6
Other Operating Modes
6 – 12
Note: Tape port settings are valid only when Writing to Tape or Reading
from Tape .
PGMR / PRNTR SETUP
The following settings are available when you select PGMR / PRNTR
SETUP . Use the keyboard spacebar or [SELECT] to cycle through the
choices. The default value appears in bold.
Parameter Available choices
Baud Rate 300, 1200, 2400, 4800, 9600, 19200
Data Bits 7 or 8
Parity None, Odd, Even
Handshaking None, Soft(ware), Hard(ware)
Below are the settings of the RS-232 Port when the Print Stack or Print Mode
function is active. The following settings are acceptable for these parameters.
Note that entries out of range will not be accepted by the DL40. Press
[ENTER] to accept a parameter setting.
Parameter Available choices
Null Count 0 to 255
Width 20 to 132
RS-232 Tape Recorder Settings
Note that RS-232 Tape Recorder Settings are valid only when writing to
or reading from a tape drive, and that communications to a tape recorder can
be made only via the RS-232 port.
Baud rate is the only modifiable parameter applicable while using a tape
recorder. Your choices are listed below. The default value appears in bold.
Use the keyboard spacebar or
[SELECT] to cycle through baud rate choices.
Parameter Available choices
Baud Rate 300, 1200, 2400, 4800, 9600
This setting will revert to normal RS-232 Port settings (described above)
when the Tape function is finished.
RS-485 Port
The following settings are available for the RS-485 Port. The default value
appears in bold. Use the keyboard spacebar or
[SELECT] to cycle through
baud rate choices. Press [ESC] or [MSG ACK] to quit without saving any
changes to communications parameters.