Set port parameters mode – Rockwell Automation 2706 DL40 HARDWARE USER MANUAL User Manual
Page 57

Chapter 6
Other Operating Modes
6 – 11
READ COMPLETE
XXXX GOOD YYYY FAIL
If you stop the read (by pressing
[ESC]
or
[MSG ACK]
), the DL40 will
display:
USER ABORTED READ
XXXX GOOD YYYY FAIL
Pressing the
[ESC]
key or
[MSG ACK]
push button will return the DL40 to
the
READ FROM
prompt.
Error Messages
NO INPUT FROM TAPE
If no data of any kind has been received from the tape port.
TAPE TIMEOUT
If some data is received but input stopped before complete file was read.
INVALID TAPE HEADER
If the application file on the tape is incompatible with the DL40 and cannot
be uploaded or if baud rates are different.
BAD SYS ATTRIBUTES
If the attributes chosen under SETUP in the Offline Programming Software
are incompatible with the DL40.
ERROR WRITING MEMORY
If the DL40’s internal memory circuitry is bad.
This mode lets you set the operating parameters of the RS-232 Port or
RS-485 Port from a keyboard or the front panel. See Chapter 8 for uses of
these ports.
Note: You can also use the Offline Programming Software to set port
parameters.
Use a
[CTRL][R]
from the keyboard or the
[SELECT]
and
[
↵
]
push buttons
on the front panel to enter this mode.
Select either
SET RS–232 PORT
or
SET RS–485 PORT
.
RS–232 Port
After you select the the RS-232 port you will be able to select either
PGMR /
PRNTR SETUP
or
TAPE PORT SETTINGS
.
Set Port Parameters Mode