Rockwell Automation 2706 DL40 HARDWARE USER MANUAL - Manual (Page 36)

Chapter
4
Chapter 4
The Run Mode – Parallel Port
Figure 4Table 4
4 – 1
Chapter 3
The Run Mode – Parallel Port
This chapter describes the operations of the Run Mode for the Parallel Port
version of the DL40. Refer to Chapter 3 for information on the Run Mode for
Remote I/O versions of the DL40. See Chapter 6 for information on other
operating modes. Refer to Chapter 9 for additional technical information on
using the parallel port.
Run Mode is the normal operating mode for the DL40. In Run Mode,
messages are triggered for display on the DL40 and (if desired) on slave
message displays.
The Parallel Port version of the DL40 always comes up in the Run Mode
after reset, except when the message display’s
Run Mode/Debug DIP
switch is set to Debug .
Parallel Port DL40s offer two types of Run Modes:
•
Message/Variable/Slave
•
Message List
You can select the type of run mode you want as an Option using the
Onboard Editor or Offline Programming Software. Table 4.A provides an
overview of the differences between Run Mode Types.
Overview