Options – Rockwell Automation 2706 DL40 HARDWARE USER MANUAL User Manual
Page 75

Chapter 7
Messages
7 – 12
Acknowledge message
Enabling this attribute will instruct the DL40 message display to hold the
message until you press the
[MSG ACK]
button on the front of the DL40
display. The next message will be displayed only after the
[MSG ACK]
button has been pushed.
Note: We recommend that you enable message queueing when using
Acknowledge msg
attribute.
Type
[Y][
↵
]
to activate or
[N][
↵
]
to deactivate.
Notes on Using Message Attributes
•
If the defaults are changed, changes will apply only to messages created
after that change.
•
To change the Message Attributes of a single existing message, use the
[CTRL][A]
editing function.
•
Some message attributes can be entered only via the Offline Programming
Software. They include:
–
Slave Message Color
–
Slave Message Length
–
Echo Relay to Slave
•
Characters from the Extended ASCII Character Set can only be entered
via the Offline Programming Software. See Appendix A.
•
Refer to the Dataliner DL40 Series Offline Programming Software User
Manual (Publication 2706–808) for additional information.
The Onboard Editor allows you to control a number of options from the
keyboard.
With the Onboard Editor you can:
•
select the Run Mode
•
determine where and how new messages are displayed
•
specify a message to AutoRun
•
specify a background message
•
set Special Message numbering to begin at 01 or 900
•
enable or disable message queueing
•
control the time display format
To modify Options:
1. enter the Onboard editor with
[CTRL][X]
Options