Rockwell Automation 2706-P42_P43_P44_P72_P74_P92_P94 InView Marquee Message Display User Manual - Manual (Page 50)

Publication 2706-UM016D-EN-P - March 2006
2-12 InView System Connectivity
The 2706-PENET1 module is the communication interface for Ethernet
TCP/IP. This module is used with the 2706-P22, 2706-P4x, and
2706-P7x displays. The 2706-P9x displays have this protocol built in.
Note that the 2706-PENET1 is Ethernet TCP/IP or Office type Ethernet
and is not Ethernet I/P, which is Ethernet Industrial Protocol available
on Rockwell Automation logic controllers.
To set the IP address:
1. Select the display you created, which use a the Ethernet module.
2. Right click on the display and select Edit Display.
3. When the Edit Display window appears, go to the
Communications tab.
This is where the configuration utility is located.
TIP
Double-clicking on the display takes you to the
same window.