Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 94)

9-14 Troubleshooting
Publication 1747-6.1
PROCESSOR ERRORS
Error
Code
Module Display Fault Description
xx5B SLOT xx BAD CFG
G file configuration error – User program G file
size exceeds the capacity of the module.
xx5C SLOT xx BAD CFG
M0-M1 file configuration error – User program
M0-M1 file size exceeds the capacity of the
module.
xx5D SLOT xx SI/O ERR
Interrupt service requested is not supported by
the processor.
xx5E SLOT xx SI/O ERR Processor I/O driver (software) error.
xx60 thru
xx6F
SLOT xx SI/O ERR
Identifies an I/O card specific recoverable
major error. Refer to the user information
supplied with the card for further details.
xx70 thru
xx7F
SLOT xx SI/O ERR
Identifies an I/O card specific non-recoverable
major error. Refer to the user information
supplied with the card for further details.
xx80 thru
xx8F
SLOT xx SI/O ERR
Identifies an I/O card specific non-recoverable
major error. Refer to the user information
supplied with the card for further details.
xx90 SLOT xx MOD ERROR Interrupt problem at the specified disabled slot.
xx91 SLOT xx MOD ERROR The specified disabled slot has faulted.
xx92 SLOT xx INT ERROR Invalid or non-existent module interrupt.
xx93 SLOT xx MOD ERROR Unsupported I/O module specific major error.
xx94 MOD IN SLOT xx
In the processor run or test mode, a module
has been detected as being inserted under
power. Code xx94 also can mean that an I/O
module reset itself.