Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 29)

Module Setup Procedure 3-7
Publication 1747-6.1
Accepting Module
Setup Parameters
If you accept the new configuration, the parameters are written to the
module’s nonvolatile memory. If you reject the new parameters, the
previous setup configuration remains unchanged.
• To accept the configuration:
Press [ (17(5 ].
• To reject the configuration:
Press [ (6& ].
The module then performs a reset and self test. Upon completion, the
LCD displays one of the two Ready screens. Refer to chapter 4,
Attaching to a Processor, for a description of these displays.
Using the Module
Reset
The module reset key sequence is available at any time and during
any function sequence. Use it when a nonrecoverable fault condition
error code is displayed or when the module appears to be
nonfunctional. Refer to chapter 9, Troubleshooting, for fault
conditions and error codes.
To reset the module:
Press [ ] [ ] [ (17(5 ] simultaneously and hold until this message
displays:
This reset message continues to display during the reset procedure
and the diagnostic test which follows. Upon completion, one of the
Ready screens displays.
Accept Setup
Confirm?
DTAM Reset
In Progress