Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 34)

4-4 Attaching to a Processor
Publication 1747-6.1
If you press and release the [ 6+,)7 ] key, then press and release the
[ (6& ] key, the display appears as:
To restore the default value of 15, press and release the [
6+,)7
] key,
then press and release the [ (6& ] key.
Attaching to a
Password Protected
Processor
In either of the previous procedures, if the processor you are attaching
to is password-protected. The module displays:
1. Use the numeric keys to enter the password.
2. As the password keys are pressed, the module displays asterisks
in the lower right hand corner.
3. When the password is complete:
Press [ (17(5 ].
4. When the password is accepted, the Ready Attached screen
displays:
If any variations of the above procedures occur, refer to chapter 9,
Troubleshooting.
5. After successfully attaching to a processor, you can now:
• Change the module setup. Refer to chapter 3, Module Setup
Procedure.
• Clear an existing Quick Recall Function. Refer to chapter 6,
Quick Recall Functions.
• Observe and respond to a displayed message. Refer to chapter 8,
Message Capability.
Attach to CPU?
3
Enter Password?
Important: During password entry, if you backspace to the
beginning of the password (using [
6+,)7@ >(6& ]),
your password entry is invalid. the following message is
displayed:
RDY>
Function Failed
RDY> 4 RRUN
5/02 4444