Rockwell Automation 1747-DTAM-E,D17476.1 Data Table Access Module (DTAM) - Manual (Page 25)

Module Setup Procedure 3-3
Publication 1747-6.1
Entering the Setup
Mode
To change the Setup configuration, the module must be in the Modify
mode. This is indicated by the flashing green Communications LED.
To review the Setup configuration, the module must be in the Modify
mode. Press the
>(17(5@ key repeatedly until the procedure is
complete.
After the module is powered up and the self diagnostics are
completed, the LCD displays the Ready Unattached screen:
To enter the Setup mode:
Press >@>,1&@ simultaneously, and hold until the display shows:
This display prompts you to confirm:
• If you want to initiate the setup procedure:
Press >(17(5@
• If you want to return to the previous display:
Press >(6&@
When the setup mode has been initiated, the Communications LED
turns off.
RDY>
Modify Setup
Confirm?
Important: Once you initiated the setup procedure, only the >,1&@ ,
>'(&@ and >(17(5@ keys are functional.
If the unit disconnects, a power failure occurs, or the
module is switched from Modify to Monitor mode
while in the setup procedure, no new parameters are
saved.