Rockwell Automation 1770, D17706.5.16 Ref Mnl DF1 Protocol Command - Manual (Page 194)

10–23 Diagnostic Status Information
Publication 1770Ć6.5.16 - October 1996
Bytes Description Contents Bits
19 all Debug mode = 0, OFF
0 0, ON
20 - 21 all Hold point file used if Debug mode is ON. Low byte first.
22 - 23 all Hold point element used if Debug mode is ON. Low byte first.
24 - 25 all Edit time stamp seconds Low byte first.
26 - 27 all Edit time stamp minute Low byte first.
28 - 29 all Edit time stamp hour Low byte first
30 - 31 all Edit time stamp day Low byte first
32 - 33 all Edit time stamp month Low byte first
34 - 35 all Edit time stamp year Low byte first
36 all Port number this command received on
For status information from these cat. nos. See page
5130ĆRM1, ĆRM2 (PLCĆ5/250) controllers 10-23
5130ĆRM1,ĆRM2 (PLCĆ5/250) Status Bytes
Bytes Bits Contents Description
1 0 - 2 Operating status of
PLCĆ5/250 processor
0 = Program load
1 = Not used
2 = Run mode
3 = Not used
4 = Remote program load
5 = Remote test
6 = Remote run
7 = Not used
3 0 = Normal
1 = Major processor fault
4 0 = Normal
1 = Download mode
5 0 = Normal
1 = OffĆline
6 0 = Not testing edits
1 = Testing edits
7 0 = No edits in processor
1 = Edits in processor
2 0 - 3 Processor Type 0E = expansion byte
4 - 7
yp
D0 = PLCĆ5/250
3 all ID
4 0 Forces active if 1
1 Backup system active if 1
2 Partner system active if 1
3 Edit resource allocated if 1
4 Outputs reset if 1
5 Memory invalid if 1
6 SFC forces active if 1
7 Edit resource allocated by user if 1
5 all Processor Station Address on Link
5130 Cat. Nos.