Rockwell Automation 1770, D17706.5.16 Ref Mnl DF1 Protocol Command - Manual (Page 135)

8–8 Message Packet Status Codes (STS, EXT STS)
Publication 1770Ć6.5.16 - October 1996
Command Explanation STS Code EXT STS Code
PLCĆ3 word write - 10 • There are not at least two bytes of data after the
end of the block address.
• There is an odd number of data bytes after the end
of the block address.
• The sum of packet offset and size values specifies
more than 65,535 words.
• The sum of packet offset and size is greater than
total transaction size.
- 30 The local PLCĆ3 interface module has executed a
shutdown request.
- 40 A backplane error (either memory parity, timeout, or
disconnect) has occurred.
- 60 The processor keyswitch setting does not allow
access.
- 70 The local PLCĆ3 processor is in Program mode.
1 F0 There is an error in converting the block address
(major section > 63, context >15, or section >15).
2 F0 Three or fewer addressing levels specified for a
PLCĆ3 word address.
3 F0 The conversion of a file address to a block address
resulted in more than nine addressing levels.
4 F0 The symbolic address was not found.
5 F0 The symbolic address is of length zero or is longer
than eight bytes.
6 F0 • The DST file was not found.
• The DST address does not point to a word (for
wordĆrange writes) or a file (for file writes).
• The DST address specifies more levels than
required.
• The first word of the DST location does not exist.
7 F0 • Any word in the total transaction does not exist in
the DST file.
• For a file write, the SRC and DST files are not the
same size.
8 F0 The DST file size changed between packets of a
multiĆpacket transaction and became too small for
the total transaction.
9 F0 There are more than 65,535 words in the SRC file.
A F0 The sum of total transaction size and the word level
PLCĆ3 addressing is greater than 65,535.
B F0 The source node does not have access to the DST
file.