Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 41)

MultiSight™ User Manual
Start-up
10000000877(02) 41
Case 3) Output Delay = Time (in ms) between the Trigger and the availability of results from Output 1+2 (Pass/Fail). Note that the
Output Delay must be longer than the evaluation time.
Case 4) Output Duration = Duration (in ms) of the result output on Outputs 1+2. The outputs will turn OFF once the Output Duration
is complete (unless the Output Active parameter is set to LOW/Normally Closed, in which case the outputs will turn ON once the
Output Duration is complete)
When the configurable delays are used, the minimum total cycle
time will be at least as long as the sum of the delay times. This will
reduce the number of inspections that can be made in a given
period of time.
A new part cannot initiate a trigger signal until the previous
evaluation, timing delays, and output duration are complete.
IN1
(Trigger)
Output Delay
(Includes Evaluation Time)
Ready On " Ouput Valid
OUT4
(Ready/Busy)
OUT 1+2
(Pass/Fail)
IN1
(Trigger)
Evaluation Time
+ Output Duration
Ready ON "
Output NOT Valid
(Output OFF)
Output
Duration
(Output Valid)
OUT4
(Ready/Busy)
OUT 1+2
(Pass/Fail)
Evaluation
Time