Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 11)

MultiSight™ User Manual
Network Settings
10000000877(02) 11
Connection of the MultiSight with EtherNet/IP to a PC and PLC via a network:
Power and I/O Connection (b)
Connector pinouts and a detailed wiring diagram are shown in the “Connector Pin Assignments” section on page 66.
Network Settings
If the “Control Input” parameter of the active detector is set to
“Enable” (the default setting), the control input (IN2) must be
connected to V+ (24V DC) in order to operate the sensor with an
external trigger (input IN1) (see page 66).
The following instructions indicate how to change the network
configuration of the PC and the MultiSight. If incorrect settings
are used, the network links in the computer may be lost. Note the
current settings for later use before making any changes.
It may be necessary to re-start the system during this procedure.
In order to determine which IP addresses are allowed in your
network or locally in your PC, and to carry out the necessary
settings on your PC, contact your system administrator.
The illustrations, dialogues and menus originate from the
operating system Microsoft Windows XP
TM . The illustrations are
similar in other operating systems.
E
48MS
PC
Ethernet Cable
1585J-M8TBJM-2*
Ethernet Cable
1585J-M8TBJM-2*
Network
e.g. Switch, Hub, etc
Standard
Network
Cable
RJ45 RJ45 RJ45
RJ45
Ethernet
Connector
1585A-DD4JD
EtherNet Cable
1585D-M4TBDM-2*
M12 RJ45 PLC EtherNet/
IP Scanner
48MS-M12CVR
M12
IMPORTANT