Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 18)

MultiSight™ User Manual
Start-up
18 10000000877(02)
Firmware Update
This function allows you to update the software of the MultiSight.
To update the software of the MultiSight proceed as follows:
Open the MultiSight software.
“Find” and select the desired sensor.
Click on the button “Update” and select the desired update file.
Switch the MultiSight Sensor off and on again.
Reconfigure the MultiSight Sensor with the PC software.
Start-up
Before using the Update function, consult your Support group
and use only the original update files from the manufacturer. The
execution of the function must not be interrupted as this may
cause failure of the MultiSight. The stored detector configurations
are deleted by the update and must be redefined when the
function is concluded.
Rockwell Automation supplies defect-free software for
installation in the customer‘s plant and integration in the
customer‘s computing system. Rockwell Automation is not liable
for any interference, failure or damage to the customer‘s system
caused by the installation or integration of this software.
These conditions are accepted by the customer without
reservation by clicking the button at the start of the software-
installation process.
The MultiSight functions only with software supplied. Software
updates are available online at www.ab.com/go/multisight.
The PC Software must always match the corresponding sensor
firmware.
Installation of older versions of the software using Windows 98,
2000 and XP™, requires administration rights. Please download
the latest version of the software from the above location.
IMPORTANT
IMPORTANT