Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 24)

MultiSight™ User Manual
Start-up
24 10000000877(02)
Commands
The buttons shown along the left hand side of the screen are for the general operation of the MultiSight, administration of detector
configuration and displaying other information on the program.
If a button is not active (i.e., greyed out) then that command is not
available in the current mode.
Command Description
Connect/Disconnect Connect to or disconnect from MultiSight (see Setup).
Connect:
Last IP—connects to the most recent IP address used
Default IP—connects to the default IP address 192.168.100.100
New IP—type in IP address to connect to
Find—Opens sensor finder (use when IP address of MultiSight is unknown)
Listed IP addresses—recently used IP addresses. Connect to an address by clicking on it.
Disconnect:
Existing connection to MultiSight is disconnected. MultiSight goes into run mode.
Teach
Teach the pattern ( or contour) currently in the red pattern box in the image window.
Also used to determine the shutter speed (when Shutter Adjustment parameter is set to
Automatic).
The Teach command does not affect other configuration
parameters. Other configuration parameters are changed on
the MultiSight as soon as they are changed in the software.
Teach from MultiSight image—the MultiSight will take a new picture and learn the pattern
or contour in the red pattern frame. Note: this image could be different than what is
currently displayed, if the part has moved or a setting has been changed.
Teach from PC image—[Recommended method] the MultiSight will learn the pattern or
contour in the red pattern frame of the image currently displayed in the image section of the
software.
E