Rockwell Automation 48MS MultiSight Vision Sensor - Manual (Page 17)

MultiSight™ User Manual
Network Settings
10000000877(02) 17
Connect all cables correctly
1. Connecting cable
2. Ethernet cable (straight)
Obtain IP address for sensor
from system administrator
If necessary execute IPConfig.
Determine IP of PC and note
yes
no
no
Failure
Failure
All cables correctly connected?
Check settings, adjust if necessary
Success
Success
no
Done
yes
yes
Electrical connection ok?
MultiSight Pwr LED on
Network: Start/Settings/Network connections
No red X on Local Area Connection
Click Connect/Find in MultiSight PC Software
Sensor is listed with IP
Click Connect/Find in MultiSight PC software
and make connection with "Connect"
IP Address area of sensor and PC identical?
i.e., IP aaa.bbb.ccc = identical
Check software and sensor version?
Execute "ARP"
Start/run/arp -a -d
Confirm (via LAN properties) that firewalls,
wireless networks, and check point
secure remote are disabled
Execute "Ipconfig"
Start/run/cmd: input. "ipconfig"
Reset IP address of sensor
i.e., aaa.bbb.ccc. = identical to PC IP
address area
.ddd = different
Execute "Ping"
Start/run/cmd/ping "IP-Adr.Sensor"
e.g., "192.168.100.100"