Yamato Scientific SQ 510 Autoclave, Sterilizers - Manual (Page 62)

59
Periodical Inspection
Periodical Voluntary Inspection of Small-sized Pressure Vessel
Inspection procedures
Prep
arati
on
- Apparatus necessary for inspection -
① Tools: Cross slot screwdriver, tow monkey wrenches
② Corrected temperature sensor and temperature recorder measurable up to 200℃
③ Corrected pressure gauge with the pressure range of 0.4MPa
④ Pressure device (a compressor capable of pressurizing up to 0.3MPa or high-pressure
nonflammable gas cylinder. Automobile inflator may be used.
⑤ Pressure-proof rubber hose (inner diameter: 12 mm), hose band and joint
External i
nspe
ction
① Make sure that no damage, rust and deformation exist on the chamber and cover.
② Make sure that no cracks exist on the surface of cover lock.
™ The cover lock must be replaced if any cracks exist.
③ Make sure that the lock lever of cover does not slide with the cover opened.
④ Make sure that no damage and deformation exist on the packing.
™ The packing must be replaced if any damage or deformation exists.
Outer plate re
moval
① Remove the back plate, right side plate and left side plate in this order.
② For the right and left side plate, unscrew the three bottom screws respectively and remove the
plates by sliding them downward.
Back plate
Right side plate Left side plate