Yamato Scientific SQ 510 Autoclave, Sterilizers - Manual (Page 33)

30
Operation Method
Sterilization & Warm/Melting & Warm/Manual Course
MANUAL MELT
PRE HEAT
AUTO
TEMP
PRES.
STERILIZE/MELT
HEAT
EXHAUST
WARM
SAMPLE
STERILIZE
WARM /LIQUID
COOLING
FAN
WARM
℃
END
TIME
MAINT.
ENTER ENTER
WARM STERILIZER
/MELT STERILIZER
/MELT
START
WARM
STERILIZE
/NORMAL
STERILIZE SET
MEMORY
START/
STOP
6. Set the heat-retention time
① The current heat-retention time is displayed with blinking on
the time display screen. The STERILIZER/MELT lamp
blinks. Press the ∧∨ on the TIME key and set the desired
heat-retention time.
™ Set "00：00" when skipping the heat-retention process in the
manual operation.
② After setting the time, press the ENTER key to determine the
value.
MANUAL MELT
PRE HEAT
AUTO
TEMP
PRES.
STERILIZE/MELT
HEAT
EXHAUST
WARM
SAMPLE
STERILIZE
WARM /LIQUID
COOLING
FAN
WARM
℃
END
TIME
MAINT.
ENTER ENTER
WARM STERILIZER
/MELT STERILIZER
/MELT
START
WARM
STERILIZE
/NORMAL
STERILIZE SET
MEMORY
START/
STOP
7. Start operation
• Press the START/STOP key.
The equipment starts operation with the HEAT lamp blinks.
8. End operation
• The time display screen displays “END” when the operation is
completed.
Press the START/STOP key. The equipment goes into the
standby state. The lever on the cover is unlocked and the
cover can be opened.
To change or confirm the preset value during operation…
Preset values can not be changed while the equipment is in operation. Before starting operation, make
sure to confirm them and change them if required.
Press the course key currently being operated to confirm the preset value while the equipment is in
operation. The preset value has been displayed while the key is pressed.
To abort operation…
Press the START/STOP key. The equipment stops operation.
In case the operation is aborted before the pressurization process, the END lamp lights up and the time
display screen displays “END” without a buzzer sound.
In case the operation is aborted after the pressurization process, the equipment goes into the exhaust
process.
Power-off during operation
If the power is turned off due to a power failure, the operation is aborted. After the recovery, the “bLAc
oUt” is displayed to notify the power failure. Press any key to delete the “bLAc oUt”.
In case the operation is aborted before the pressurization process, the END lamp lights up and the time
display screen displays “END” without a buzzer sound.
In case the operation is aborted after the pressurization process, the equipment goes into the exhaust
process.
The operation continues if aborted during the heat-retention process.
① ②