Sensaphone IMS-1000 Users manual - Manual (Page 93)

Chapter 5: IMS-1000 Sensors
93
IMS-4860 Door Switch
Installation Instructions
Introduction
The IMS-1000 Door Switch with bridge enables your
IMS-1000 to detect if any unauthorized entry or intrusion
has occurred. The bridge may be mounted either on a
wall or rest on the floor. The switch is mounted to doors
or windows you wish to monitor. The electrical connec-
tion between the bridge and IMS-1000 is made via RJ-45
patch cable.
Package Contents
(1) Door Switch with mounting hardware
(1) IMS-4860 bridge
(1) 25′ accessory wire
Mounting the Door Switch
The door switch is usually installed to function in a normally closed position when the door (or
window or other portal) on which it is mounted is closed. The complete assembly is of two parts: a
magnet in a plastic housing, and a sensor switch with screw terminals in another plastic housing.
Mount the switch by fastening it to the non-moving frame surrounding the door or window. Use
either mounting screws or the adhesive foam tape attached to the switch segments. Fasten the mag-
net near the edge of the movable sash or door. Position the magnet housing no more than
1 /
8
" from
the switch and tighten mounting screws. Use the spacer bar (included) if needed for alignment.
Figure 1: Door switch mounting