Sensaphone IMS-1000 Users manual - Manual (Page 65)

Chapter 5: IMS-1000 Sensors
65
IMS-4813 Room Temperature Sensor with display
(Celsius)
Installation Instructions
Introduction
The IMS-4813 temperature sensor is designed
to connect to the IMS-1000 and monitor indoor
temperatures. The electrical connection between the
sensor and IMS-1000 is made via RJ-45 patch cable
(not included). The sensor may be mounted either on
a wall or to a single-gang electrical box.
Package Contents
(1) IMS-4813 Temperature sensor
(2) Plastic drywall anchors
(2) #6 Metal tapping screws
(1)
1 ⁄
16
" hex key
Cabling
The IMS-4813 temperature sensor connects to the IMS-1000 via an RJ-45 cable (e.g. CAT5 cable).
The connection from the sensor to the IMS-1000 can utilize your existing network wiring infrastruc-
ture. For example, the sensor may be installed in another room or another floor. Connect the sensor
to your structured wiring network via an RJ-45 jack. At the other end, connect a patch cable from
your structured wiring patch panel directly to the IMS-1000 environment input.
Caution: The IMS sensors are not TCP/IP devices and therefore should not be
connected directly to any wiring infrastructure that is connected to network equipment
such as a hub, router, or switch. Sensors use RJ-45 plugs and cables similar to those
used with Ethernet devices.
Mounting
The temperature sensor can be mounted directly on a surface or attached to a single-gang electrical
box. Consideration should be given to cable routing before attaching the sensor to the wall. Will the
cable go through the wall (cable hidden) or will it run down the wall (cable visible)? Once this has
been determined, run the cable to the location where the sensor will be installed.
Electrical box installation
Bring the RJ-45 cable through the electrical box. Remove the sensor cover by turning the two hex
screws on the bottom of the sensor housing clockwise. Bring the cable through the back of the sensor
and connect the cable to the jack as shown in Figure 1. Attach the sensor to the electrical box using
the appropriate screws. Secure the sensor cover by turning the two hex screws on the bottom of the
cover counterclockwise.