Sensaphone IMS-1000 Users manual - Manual (Page 49)

Chapter 2: Configuration
49
Alarm Condition and Unacknowledged Alarm Mode
To select one of these modes click the circle labeled Automatic from within the Output Mode sec-
tion of the screen. Next, click the circle for either Alarm Condition or Unacknowledged Alarm.
Next, select the Environmental Inputs and/or IP Alarms that you would like to have control the out-
put.
Touch-Tone Control
If the output is set to Manual mode you can control it using touch-tone commands over the tele-
phone. To do this call the unit and enter your User Code when prompted. The unit will begin speak-
ing and will eventually provide various menu options. Select option 5 to control the relay output.
Follow the prompts to turn the relay output ON or OFF. The unit will respond “on” or “off ” to indi-
cate that the command was executed successfully.