Sensaphone IMS-1000 Users manual - Manual (Page 20)

IMS-1000 Manual
20
Operating Environment
Before you install the IMS-1000 be sure that your operating environment meets the physical
requirements of the equipment.
Operating Temperature: 32º–122º Fahrenheit (0º–50º C)
Humidity:
5–90 %RH, non-condensing
Power: AC power outlet within 6
Rack Requirements: Standard 19" equipment rack with supplied mounting bracket
hardware. Requires 1.0 EIA rack mount space.
Tabletop requirements: Flat area which can support an enclosure 14" wide by 7" deep by 2"
high.
Rack Mount Installation
The IMS-1000 can be rack mounted using the included rack mount brackets. Follow the steps
below:
1) Attach rack-mount brackets to the sides of the unit with a Phillips screwdriver.
2) Attach the unit to the equipment rack using two pan-head screws per side. Tighten the
screws with a Phillips screwdriver.
3) Plug the power adapter into an appropriate AC power outlet.
Figure 3: Rack-mounted unit
Tabletop Installation
The IMS-1000 can be installed on a tabletop or shelf. Follow the steps below:
1) Attach the four self-adhesive rubber feet to the four corners on the bottom of the IMS-1000.
2) Place the unit on a tabletop or shelf and connect the power adapter into an appropriate AC
power outlet..
System On
Battery Ok
Output On
Alarm
Output Ethernet Expansion Phone E n v i r o n m e n t a l S e n s o r I n p u t s
1 2 3 4 5 6 7 8
1 2 3 4 5 6 7 8
IMS-1000 Infrastructure Monitoring System SENSAPHONE ®
Figure 5: Tabletop-mounted unit
Power On Self Test (POST)
When the power switch is turned on, the unit will boot up and perform internal diagnostic tests. The
boot and Power On Self Test take approximately three minutes.