beautypg.com

Alarm led, Rear panel, On/off switch – Sensaphone IMS-1000 Users manual User Manual

Page 19: Installation, Parts required

background image

Chapter 1: Installation

19

Output LED

The Output LED is a visual indication that the Output Relay has been activated.

Alarm LED

The Alarm LED is a visual indication that a Power, IP Alarm, or Battery Alarm exists. When
blinking this LED indicates that the alarm is un–acknowledged, a “steady–on” led indicates that
the alarm is acknowledged.

Rear Panel

The rear panel is where the main power switch is located. The power adapter attaches to the con-
nector. Models in the USA may be powered by a 115VAC 60Hz to 9VDC power adapter while
those outside the USA include a 100-240VAC 50/60Hz to 9VDC universal power adapter.

ON/OFF Switch

The on/off switch connects main power and battery power to the system. Note that the system will
only turn on when main power is present. When main power fails, the internal battery will auto-
matically supply power to the unit.

Power Switch Power Jack

Figure 2: Rear Panel of the IMS 1000

Installation

This section provides information on:

n

Operating environment

n

Rack, and tabletop installation

n

Connecting sensors

Parts Required

Phillips

Cat 5 Network

Computer

Screwdriver

Cable