Sensaphone IMS-1000 Users manual User Manual
Page 22
IMS-1000 Manual
22
Figure 6: Configuration
Change the DHCP Status to Disabled and enter a permanent fixed IP address. Enter the other net-
work settings also. Consult with your network administrator if your unsure of the proper settings.
Click Save when done.
My network does not support DHCP:
If your network does not support DHCP then your IMS-1000 will set its IP address to
192.168.1.250. This address should only be temporarily set. Leaving this address as the factory
default could result in networking conflicts if another IMS-1000 is added to your non-DHCP sup-
ported network.
If your network does not support DHCP then you will have to use one of the following methods to
change the IP of the IMS-1000 for the first time.
NOTE: It is highly recommended that you consult all network configurations and settings
changes with your Network Administrator.
1) Using a standard RJ45 crossover cable connect your PC to the IMS-1000. Change the IP of your
network connection to something in 192.168.1.xxx that is not the same as the default IP of the
IMS-1000.
You should now be able to access the following configuration page of the IMS-1000. Point your
browser at the following URL:
http://192.168.1.250/config.asp
Proceed to the Network Configuration section below.
2) Using a network hub connect only your PC and the IMS-1000 to the hub. Change the IP of your
network connection to something in 192.168.1.xxx that is not the same as the default IP of the