Sensaphone 400 - Manual (Page 92)

90
SENSAPHONE 400 User’s Manual
6 .2 .4 battery CondItIon
During a Status Report, you may hear one of three possible messages
regarding battery power. The Model 400 determines the appropriate mes-
sage by measuring battery voltage. Depending upon the remaining voltage,
it may respond:
• “The batteries are OK,” if over 8.2 Volts.
• “The batteries are low,” if between 7.2 and 8.2 Volts.
• “Replace batteries,” if below 7.2 Volts.
6 .2 .5 remote aCCeSS by touCh-tone™ telephone
You can issue a number of commands to the 400 remotely using a Touch-
Tone™ telephone. This command mode can be entered at any time during
the status report. Simply press a Touch-Tone™ and the unit will halt the
report and respond with “OK.” You are now in Touch-Tone™ command
mode. Commands are available to perform the following functions:
• Enable and disable zones, power monitoring, and sound monitoring
• Recite/Set High and Low alarm limits
• Recite/Set telephone numbers
• Record/Play custom voice messages
• Recite/Set the relay output
• Activate the microphone for listen-in
• Recite status report
Note: If a security code is enabled, the 400 will prompt you with
“Enter security code.” Enter the four-digit keypad security code plus
“#” to enter touch-tone command mode. If entered correctly, the 400
will respond with “OK” and you can proceed to enter the commands.
If entered incorrectly, the unit will give you one more chance. If it is
incorrect a second time, the unit will say “Error, goodbye” and hang up.
The commands are put together based on the letters of a touch-tone tele-
phone. See typical telephone keypad layout below.
1 2
abc
3
def
4
ghi
5
jkl
6
mno
7
pqrs
8
tuv
9
wxyz
0