Sensaphone 400 - Manual (Page 8)

6
SENSAPHONE 400 User’s Manual
Canadian Department of Communications Statement
Notice: The Canadian Department of Communications label identi-
fies certified equipment. This certification means that the equip-
ment meets certain telecommunications network protective opera-
tional and safety requirements. The Department does not guarantee
the equipment will operate to the user’s satisfaction.
Before installing this equipment, users should ensure that it is
permissible to be connected to the facilities of the local telecom-
munications company. The equipment must also be installed using
an acceptable method of connection. In some cases, where the
company’s inside wiring is associated with a single line, individual
service may be extended by means of a certified connector assem-
bly (telephone extension cord). The customer should be aware that
compliance with the above conditions may not prevent degradation
of service in some situations.
Repairs to certified equipment should be made by an authorized
Canadian maintenance facility designated by the supplier. Any
repairs or alterations made by the user to this equipment, or equip-
ment malfunctions, may give the telecommunications company
cause to request the user to disconnect the equipment.
Users should ensure for their own protection that the electrical
ground connections of the power utility telephone lines and inter-
nal metallic water pipe system, if present, are connected together.
This precaution may be particularly important in rural areas.
CAUTION: Users should not attempt to make such connections
themselves, but should contact the appropriate electric inspection
authority, or electrician, as appropriate.
The Load Number (LN) assigned to each terminal device denotes
the percentage of the total load to be connected to a telephone loop
which is used by the device to prevent overloading. The termina-
tion on loop may consist of any combination of devices subject
only to the requirement that the total of the Load Numbers of all
the devices does not exceed 100. For the Sensaphone
®
Model 400,
the Load Number is 0.3.