beautypg.com

Sensaphone 400 User Manual

Page 54

background image

52

SENSAPHONE 400 User’s Manual

4 .6 .4 SpeCIal dIalIng to a beeper or pager
Your Sensaphone can be programmed to send an alarm message to a

numeric beeper/pager. The message will include the Sensaphone’s tele-

phone number (ID number) and the Zone numbers that are in alarm. For

example, if zones 1 and 4 are in alarm, the message on your pager would

be: 8882227777-1-4, where 8882227777 is the unit’s ID number. A Sound

alarm will appear as alarm -9 and a Power alarm will appear as alarm -0.

To program a telephone number for Pager dialout, you must enter Code 1

at the beginning of the telephone number. The Sensaphone will say “Code

one, Pager” when you enter the command.

Follow the key sequence below to dial a numeric pager:
SET + PHONE NUMBER + any unassigned number key 1-4 +
CODE + 1 + pager telephone number + ENTER

To check your programming:
WHAT IS + PHONE NUMBER + assigned # 1-4

The Sensaphone will say “Pager”, followed by the programmed telephone

number.

To send a test page:
SET + TEST + assigned # key 1-4 + ENTER

The Sensaphone will let you listen to the dialout sequence through its

speaker and send you a message that includes the Sensaphone’s telephone

number (ID number).
Voice Prompted Paging Systems
If your paging provider is answered by a voice prompt which requires you

to enter one or more touch-tones to send a message, then use the wait-for-

answer code (4.5.1) in combination with the Pause key and other number

keys to navigate the voice menu until you reach the message entry point.

The Sensaphone will automatically send it’s telephone number, Zone num-

bers, and a pound (#) tone at the end of the number. For assistance contact

Sensaphone Technical Support at 1(877)373-2700.