Sensaphone 400 - Manual (Page 84)

82
SENSAPHONE 400 User’s Manual
5. Press ENTER.
ENTER
PM
5 .10 .4 InterrogatIng hIgh Sound
alarm reCognItIon tIme
The Recognition Time for sound alarm monitoring ranges from 5 seconds
to 60 seconds. The default value is 8 seconds.
1. Press SET.
WHAT
IS
2. Press RECOGNITION TIME.
7
RECOGNITION
TIME
3. Press SOUND. The Model 400 responds: “Enter seconds.”
9
LISTEN TIME
SOUND
5 .11 hIgh Sound alarm enable/dISable
The Model 400 monitors sound through the built-in microphone. When
the sound level suddenly exceeds the programmed high sound limit, the
Model 400 will respond with an alert condition. The increased sound level
must continue throughout the programmed recognition time. The default
for high sound alarm is enabled (on).
NOTE: The microphone is also used for listening to on-site sounds.
Refer to Chapter 4, Section 4.8. Disabling the sound alarm does not
affect listen-in capability.
5 .11 .1 ChangIng enabled/dISabled
hIgh Sound alarm
1. Press SENSOR ON/OFF.
SENSOR
ON/OFF
2. Press SOUND. The Model 400 will say “Sound Alarm Disabled” to indi-
cate disabled or “Sound Alarm Enabled” to indicate enabled.