Sensaphone 400 - Manual (Page 105)

Chapter 8: Controlling the Output
103
8 .1 .2 to play baCk the programmed output mode:
1. Press WHAT IS.
WHAT
IS
2. Press OUTPUT.
OUTPUT
PAUSE
AM
The 400 will recite the programmed output mode.
8 .2 SwItChIng the output uSIng the keypad
When programmed for Manual mode, the command to switch the output
is:
SENSOR ON/OFF + OUTPUT.
SENSOR
ON/OFF
OUTPUT
PAUSE
AM
The 400 will respond “The output is on/off” to indicate the state of the
output.
Note: If the 400 says “Error,” the output is not programmed for manual
mode.
8 .2 .1 SwItChIng the output over the phone
The following commands will allow you to check the status of the relay out-
put and to toggle the Relay Output On and Off.
To recite the Output Status press W(9) + R(7) + O(6)
9
wxyz
7
pqrs
6
mno
To switch the Output press S(7) + R(7) + O(6)
7
pqrs
7
pqrs
6
mno