Sensaphone 400 User Manual
Page 91
Chapter 6: Acknowledgment, Status Report & Remote Access
89
Zone 3 “Water pressure alarm in greenhouse”, not OK, acknowledged alarm
exists
Zone 4 “Greenhouse control system”, not OK, acknowledged alarm exists
A High Sound alarm exists, it is now too high
The Power is Off.
The Batteries are Low.
The Output is Off.
Listen to the sound for 10 seconds.
Goodbye.
6 .2 .3 example: StatuS report, dISabled ZoneS
If a zone is disabled, the dial-out feature for that zone is deactivated, but all
other programmed parameters remain in effect. In the example below, all 4
zones are disabled, although zones 1 and 3 are detecting alarms. AC power
and Sound Level are also disabled for dial-out. When you call the Model
400 for a Status Report, you hear the following:
Hello, this is 555-1234; “this is the Sensaphone 400 at ACME Greenhouse, 225
Oak Street”
It is now 8:45 PM
Zone 1, “Temperature in greenhouse”, the alarm is disabled, it is now 110
degrees Fahrenheit, too high, acknowledged alarm exists
Zone 2, “Door alarm in greenhouse”, the alarm is disabled, it is not OK.
Zone 3 “Water pressure alarm in greenhouse”, the alarm is disabled, it is not
OK.
Zone 4 “Greenhouse control system”, the alarm is disabled, it is not OK.
The Sound alarm is disabled, it is now too high
The Power alarm is disabled, it is now Off.
The Batteries are Low.
The Output is On.
Listen to the sound for 10 seconds.
Goodbye.
The Status Report repeats once more and the Model 400 concludes the call,
saying: “Goodbye.”