Sensaphone 400 - Manual (Page 34)

32
SENSAPHONE 400 User’s Manual
3 .3 QuICk-Start programmIng StepS
STEP 1: SET CONfIgUrATION Of ZONES
The Model 400 will scan the 4 external zones and determine if they are
N.O. (normally open), N.C. (normally closed), or Temperature. If external
sensors are added, make sure they are in their normal positions before
proceeding—refer to Chapter 5, Section 5.1.
1. Press STANDBY to place the Model 400 in Standby mode.
RUN
STANDBY
2. If you have external sensors available, wire the sensors to the zones on
the back of the Model 400 (see Chapter 2, Section 2.10). Otherwise, skip
this step and move to step 3.
3. Press RUN. The System On light glows when the Model 400 returns to
Run mode.
RUN
STANDBY
4. Press SET.
SET
5. Press CONFIGURE.
CONFIG
6. The Model 400 will audibly recite the new configuration for each of
the four zones, responding with “normally open”, “normally closed”, or
“Temperature.” If a zone is unused, it is treated as normally open.
STEP 2: SET ThE ID NUmBEr
It is recommended that you set the ID number to reflect the telephone
number on which the Model 400 is installed.
1. Press SET
SET
2. Press ID NUMBER.
0
ID NUMBER
POWER