Sensaphone 400 User Manual

Page 51

Chapter 4: Communications Programming

Code 2 Wait-for-Answer
You can force your Sensaphone to Wait-For-Answer in the middle of dial-

ing a telephone number. This is useful when calling a telephone extension

that is initially answered by an auto-attendant. By inserting the wait-for-

answer code you can instruct your Sensaphone to call the main number,

then wait for an answer by the auto-attendant, then dial the extension.

The Sensaphone will not speak it’s voice message until the telephone is

answered at the extension.
Example:
SET + PHONE NUMBER + any unassigned number key 1-4
+ telephone number + CODE + 2 + extension number + ENTER

Code 3 Switch to Touch-tone
This command allows you to change from pulse dialing to touch-tone dial-

ing in the middle of dialing a telephone number. This is useful when your

telephone service only supports pulse dialing, but you need to send touch-

ones after connecting – such as when dialing a numeric pager or navigating

a voice menu.
Example:
In this example a telephone number is dialed, the Sensaphone waits for the

call to be answered, then changes to touch-tones to dial an extension.
SET + PHONE NUMBER + any unassigned number key 1-4 +
telephone number + CODE + 2 + CODE + 3 +
extension number + ENTER

4 .6 .2 InCorporatIng a pauSe

Incorporate PAUSE to access an outside telephone line:

1. Press SET.

SET

2. Press PHONE NUMBER.

PHONE

NUMBER

T/P