Sensaphone 400 User Manual

Page 26

SENSAPHONE 400 User’s Manual

To install the telephone line, plug one end of the modular cord into the

“line” jack on the back of the model 400 (as shown) and plug the other end

into any standard RJ11 phone outlet.
Refer to Figure 2-4.

AC Power
Transformer
(plug into
120 VAC outlet)

RJ11 Outlet
(for modular
telephone jack)

Modular Plug
(plug into RJ1 jack)

Female Telephone Jack
(connect telephone here)

Line Ext Pwr

Figure 2-4. Installing the Telephone Line

On the back of the Model 400 is an extra female telephone jack labeled

“EXT”. This is provided so that a telephone or other answering device

may be used on the same line as the unit. (It is not necessary to hook up a

telephone for the Model 400 to operate.) This extension jack features Line

Seizure which means that it will disconnect the extension jack when the

Model 400 needs to make a telephone call. To ensure that the unit has pri-

ority over any other device on the line, you must connect all extensions to

this jack. (see figure)
On the unit there are two RJ11C phone jacks:

• The RJ11C jack labeled “LINE”is to be connected to the incoming line

of your phone service, ahead of all other phones or telephone extensions.
• The RJ11C telephone jack labeled “EXT” is to be connected to all

extensions.