Center punch on mark – SDC 1511T EXIT CHECK DELAYED EGRESS EMLOCK User Manual

Page 4

Door and Frame Reference

Door and Frame Preparation Instructions

HINGE SIDE OF FRAME

(OPPOSITE FROM LOCK)

PAPER TEMPLATE

STEP 1. Locate the paper template and fold
along the dotted line. Place the folded edge of
the template against the door stop and door at
the header while against the vertical stop,
opposite the hinge side of the door. Tape in
place at this position.

STEP 2.

As indicated on the paper template,

punch the designated hole locations on the
frame and armature mounting holes on the door.

(NOTE: PRIOR TO DRILLING, INSPECT TO SEE IF
ANY OF THE HOLES CANNOT BE DRILLED DUE
TO THE FRAME OR DOOR CONFIGURATION. A
FILLER PLATE OR ANGLE BRACKET MAY BE
REQUIRED. SEE PAGE 4.)

STEP 3.

Drill and tap the two 1511S mounting

holes as indicated on the paper template.

(NOTE: READ NOTE ON TEMPLATE WITH
REGARD TO SELECTING THE PROPER HOLE
SIZE FOR ARMATURE MOUNTING BOLT.)

2-1/2"

2-5/8"

11"

2-3/4”

P:\INSTALLATION INST\Delayed Egress\INST-1511ST\INST-1511ST.vsd Rev G3 10-13 Page 4

NOTES:
- #10 self drill/tap screws provided for up to 1/8" thick metal applications
- For applications with heavier gauge material, drill (#21) and tap for #10-32 machine screws.

IMPORTANT! – IT IS HIGHLY RECOMMENDED THAT YOU FIRST INSTALL THE MOUNTING PLATE AT TWO SLOT LOCATIONS ONLY.
THIS WILL ALLOW YOU TO MAKE PROPER ADJUSTMENTS OF THE LOCK’S POSITION PRIOR TO MARKING, DRILLING AND TAPPING
THE FOUR PERMANENT MOUNTING PLATE HOLES.

1/2” DIA FOR WIRE

First install mounting plate at two slot locations only and make proper
adjustments before marking remaining five mounting hole locations.

FOLD ON DOTED LINE

Mark location five places:

#10 self dril/tap screws provided for up to 1/8” thick metal applications.

Note: Machine screws provided for applications with heavier

gauge material – Drill (#21) and tap for #10-32 screw.

PLACE AGAINST LOCK JAMB FOR L.H. DOORS

1/4” DIA GUIDE PIN HOLE 9/16” DEEP

PLACE AGAINST
LOCK JAMB FOR

R.H. DOORS

PLACE AGAINST DOOR

Center punch on mark

PLACE AGAINST HEADER