MacDon 742 HAY CONDITIONER - Manual (Page 51)

Form # 46290 Issue 09/05 49
OPERATION
STORAGE PROCEDURE
Do the following at the end of each operating season:
1. Clean the header thoroughly.
CAUTION: Never use gasoline, naphtha or any volatile material for cleaning purposes. These
materials may be toxic and/or flammable.
2. Cover cutterbar and sickle guards to prevent injury from accidental contact.
Also:
3. Store machine in a dry protected place if possible. If machine is stored outside, cover with a waterproof
canvas or other protective material.
4. If machine is stored outside, remove drapers and store in a dark, dry place.
NOTE: If drapers are not removed, store header with cutterbar lowered so water/snow will not accumulate
on drapers. This accumulation of weight puts excessive stress on drapers and header.
5. Lower header onto blocks to keep cutterbar off the ground.
6. Lower reel completely. If stored outside, tie reel to frame to prevent rotation caused by wind.
7. Repaint all worn or chipped painted surfaces to prevent rust.
8. Lubricate the machine thoroughly, leaving excess grease on fittings to keep moisture out of bearings. Oil
cutterbar and apply grease to exposed threads and sliding surfaces of components.
9. Check for worn or broken components and repair or order replacements from your dealer. Attention to
these items right away will save time and effort at beginning of next season.
10. Replace or tighten any missing or loose hardware. See Specifications section for torque charts.