MacDon 742 HAY CONDITIONER - Manual (Page 101)

Form # 46290 Issue 09/05 99
UNLOADING WINDROWER FROM TOPSIDE
UNLOADING & ASSEMBLY
UNLOAD HEADER
WARNING: Do not unload header by
lifting at cutterbar. This will cause
header to swing or tilt, as one side of
the header is heavier than the other.
WARNING: Be sure forks are secure
before moving away from load. Stand
clear when lifting.
NOTE: Shipping damage or shortage must be
noted on the trucking company’s copy of the bill of
lading. Once the bill of lading is signed, dealer is
liable for any damage or shortage not noted.
1. Approach header from either its "topside" or
"underside". Drive forward as far as possible,
with the forks underneath the lifting framework.
Take care not to bend parts on back tube.
2. Remove hauler's tie down straps and chains.
3. Raise header off deck, back up until unit clears
trailer and slowly lower to 6 inches (150 mm)
from ground.
4. Take to storage or set-up area.
5. Set machine down securely on level ground.
Check for shipping damage and missing parts.
UNLOADING WINDROWER FROM UNDERSIDE