JUMO 701550 di 308 - Digital Indicator Operating Manual - Manual (Page 57)

57
7 Configuration
Ticker time
(ticker) TICKER-t 0
1
2
3
4
5
6
7
8
9
10
100ms (fast ticker)
200ms
300ms
400ms
500ms
600ms
700ms
800ms
900ms
1000ms
1100ms (slow ticker)
Decimal point
(system point) DECPOINT 0
1
2
3 no digit after the decimal point
one digit after the decimal point
two digits after the decimal point
three digits after the decimal point
If the value to be displayed cannot be shown
including the programmed decimal point, the
number of digits after the decimal point are
automatically reduced. If subsequently the
measured value contains less digits, the
reading appears with the decimal point as
programmed.
Brightness BRIGNESS 0…5 (bright) 0...5 (dark)
Time-out TIMEOUT 0…180…
255 Time period in seconds, after which the
instrument automatically returns to normal
display if no key is pressed.
Start
delay time START-t 0…3600 Start delay time in seconds after Power ON
Min/max mode MIN-MAX 0
1
2
3 Min/max mode inactive
Min/max mode active for analog input 1
Min/max mode active for analog input 2
Min/max mode active for analog input 1 and 2
Hold
(Value) (Setup) active
not
active
Hold mode for analog input 1 or 2
With the hold mode active, the current
measurement can be saved with function key
„F“ or the binary function. The saved value
can be shown in display 1 or 2 as well as in
the scroll mode.
Adjustment only possible in the setup
program:
-> Display/Operation -> Display -> Min-Max/
Hold
Parameter Value/
Selection
Description
Factory settings are shown bold.