Despatch MIC1462 Controller Manual User Manual
Page 9
5
SECTION 2: INSTALLATION & WIRING
2.1
Unpacking Procedure
1. Remove the instrument from its packing. The instrument is supplied with a panel
gasket and push-fit strap. Retain the packing for future use, should it be necessary
to transport the instrument to a different site or return it to the factory for
repair/testing.
2. Examine the delivered items for damage or deficiencies. If any is found, notify the
carrier immediately. Check that the model number shown on the label affixed to the
instrument housing corresponds to that ordered (see Appendix D).
2.2
Panel-Mounting The Setpoint Programmer
The panel on which the instrument is to be mounted must be rigid and may be up to 6.0
mm (.25 inches ) thick. The cutout required for a single instrument is shown in Figure
2-1.
FIGURE 2-1
Cut-Out Dimensions